All,
We are having a frequent problem with allocations. Our inventory is lot controlled and we are using manufacturing as well as GP 2010. Our issue is that the system is allocating more inventory than exists. In the iv00300 table the quantity received may be 2454 pcs of an item/lot number but it will show 6000 allocated. When the user attempts to use that item/lot number it shows on the screen as (3546) and they cannot do their job. This morning I kicked everyone off and ran Reconcile on a section of the parts affected. It cleared out the over allocations. I then ran it again against another group of affect parts. They were corrected but the first group is again over allocated. While we have some manufacturing orders that are completed with the inventory allocated not issued the quantities but don’t seem to match up with the issue. While I have worked with this system for four years the original setup was done around 2005 by 2-3 different consultants/companies and predates V9. Has anyone seen this issue before?